that would work for the animation, how would I make the alternating lasers, I will assume it requires the laser beam manager
Is there an updated guide using laser beam managers, I really want to start using them, they seem fun and difficult to use, since I don’t really use lasers that much
I think there is a way, but there are no guides on it and I don’t know how.
I’m sorry, I’m stupid lol
I will test some way, and report back to you
maybe this?
Is this still unresolved?
You know Thats_Gimpossible isn’t the only user that can help? Anyone can.
I tried the guide you requested, It not working
Nvm, it worked for a little bit, then stoped
What is the issue?
Did you wire the repeaters to all the lasers and did the deactivating relay come first?
It should work.
Try redoing it and debugging your setup.
it goes for a little bit, then stops completely
You need to make the stop strategy be after broadcasting on a channel but don’t actually put a channel
I did, but I will check setting again
Ok, it good now, one was on spot after time
Nvm, it still stops, all of the setting are correct i think
I will recheck them tho
Ok, Nvm my Nvm, the wire repeater was the same as my second repeater
Yeah, they have to run at different times to work.