so I wanna make it where ever blank seconds it changes the taging team but since I am new I don’t know how.
1 Like
ok start with a counter, repeater, tag zone, and lifecycle device.
now go into add section. add wires. start- connect to the lifecycle device. next connect to the repeater. it should look like this.
next go into the settings of the lifecycle device. Fix the settings to say
here you can see the repeater’s settings.
Then, when repeater runs task—increment counter
now you’re going to need a team switcher device.
add that and then add wires connecting from the counter to it.
you can make the swicth only apply to team and then make it so that it relays the command to its team and switches them too.
Now open up the tag zone device.
you can put these settings however you want just know that the tagging team must correspond to the team switcher and the team you want to switch to taggers.
Now you’re sort of done. just make sure that the repeater runs the task every second in its settings.
to make it how often it switches teams, just make it so that the counters target value is higher or lower in its settings.
2 Likes
Why didn’t you just put that all into one post?
2 Likes
sorry i probably should ill do that now
- Please Never Use Repeaters (and a guide on looping)
- The OP asked to change the tagging team, not a player’s team
4 Likes
ill check out the link but you can just use a tag zone device and only one team can tag and then just switch them to the team that can tag. I probably shouldve put that in the original post huh.
edit: or check out the tag-domination tag
2 Likes