Whenever I put on a wire that is wrong and put a new one, it shows up again

yeah but i barely know how to use channels

1 Like

maybe delete all the wires then put the right ones back

This is a channels guide:

1 Like

Ok, I also ran against that problem, except that I deleted a wire, then connected the devices through channels, but two wires got created??

make sure your doing the whole process right and connecting it on both sides.

Sorry I was offline!

btw @Cyn_the_zombie_drone I do do that but I hate it when the wrong wires respawn

I might quit the creative for a while

You can try saving the map and then going back in

It happened to me a lot too, but all I did was just delete the old one and it was good!