Whenever I put on a wire that is wrong and put a new one, it shows up again

Test if it works in game. If not, I would not consider it a problem.

1 Like

I showed you a picture while I was building my game and whenever I start the game the wires don’t show up even if it’s wrong or good

1 Like

That actually happened to me! I deleted the wire, but then when I added another, it came back! Probably a glitch since it happened to me only once.

2 Likes

it happen to me a lot of times for me I was like “How do I stop this thing?!”

1 Like

Maybe try restarting your device? Probably the glitch will disappear then.

yeah I restarted it many times but still it shows up

I had to update my laptop around 5:00 but by that time I was not doing anything wrong.

1 Like

Then just give a day, maybe the glitch will go away on it’s own?

1 Like

yeah alright can I still play the gimkit og games?

Can you use channels instead of wires, and just remove all of the wires completely?

1 Like

yeah but i barely know how to use channels

1 Like

maybe delete all the wires then put the right ones back

This is a channels guide:

1 Like

Ok, I also ran against that problem, except that I deleted a wire, then connected the devices through channels, but two wires got created??

make sure your doing the whole process right and connecting it on both sides.

Sorry I was offline!

btw @Cyn_the_zombie_drone I do do that but I hate it when the wrong wires respawn

I might quit the creative for a while

You can try saving the map and then going back in

It happened to me a lot too, but all I did was just delete the old one and it was good!