[ 📜 ] The Ultimate Guide to Gimkit Among Us

[Haiasi]

Yeah. You could do that with zones.

[IlliniSD]

How would that work, exactly?
Like the zones would teleport them to where they can input the code?

[Haiasi]

You could wire the zone to counters similar like you suggested for the Reactor Meltdown task.

Player Leaves Zone > Decrement Counter

[IlliniSD]

For some reason, in my among us game, the player leaves zone doesn’t actually work. I don’t know if this is a bug or not though.

[Haiasi]

The event doesn’t broadcast to another wire?

[IlliniSD]

Yeah, I tried using channels, but that doesn’t work.
I even put a trigger in between and gave it a delay.

[Haiasi]

How about a wire repeater?

[PearGamez]

The lifecycle when game starts activates only for the host, so the host is the impostor every time, so you need a relay that broadcasts to everyone, or a trigger, so it is truly a random person as imposter.

[Haiasi]

Wasn’t it listed in Team Setup?

@Haiasi

Team Setup (Guide by Blackhole927)

[ Difficulty or 2/10 ]

---

Team Type setting (you need this for both the wire version and channel one)

• In the bottom-left corner, you should see a button.
• Click that.
• Now go to map options.
  Click the “Teams” tab and change the team type (click on the setting) to be cooperative.

---

Wire Version:

First, place a Lifecycle, Relay and Team Switcher.

Wire your Lifecycle (Game Start) to a Relay. (Random Player)

(Lifecycle) Event Occurs > (Relay) Trigger Relay

Now, connect your Relay (Random Player) to a Team Switcher (Team 2).

(Relay) Relay Trigger > (Team Switcher) Switch Player To Configured Team

Explanation:

The Lifecycle’s event is on Game Start.
This means it can trigger an event from either wires or channels when the Game Starts.
In this case, it triggers a Relay, a device that can send a signal to a certain team only, a random person on the specific team or for all players.

Channel Version:

• Then, create a Lifecycle.
  The Lifecycle channel should broadcast on a channel called IC (Imposter Decided)
• Then, place a Relay
  The settings should be “Random Player.”
  Make the channel “relay when receiving on”broadcast on the IC (Impostor Decided) channel.
• Now, place a Team Switcher
  The switched team should be team 2.
  Make it broadcast on IC.

[PearGamez]

Yes, it may be a bug with the lifecycle, because when I did that, it was me as the impostor every single time.

[RisingTenno]

that is not good.

[IlliniSD]

Sure, I can try that.

[IlliniSD]

And it doesn’t work.
Maybe I need to add a delay.

[PearGamez]

No, it was with my friends.

[WhoAmI]

Stabilize steering is where you have to position your crosshairs over the crosshairs shown on the screen.

[PearGamez]

Lots of triggers, but 1 is right?

[Haiasi]

Is it still a problem?
If so you can make a Bugs post about it.

[GIMKING]

H…h…how lllllong did it take you to make THAT!

[Haiasi]

It took about two weeks and
Probably a few more days or ~week to finish it.

[IlliniSD]

Ok, I will.