when i span in a sentry, they are fine then, but when i host the game, they are just in the ground. How would i fix this???
1 Like
You can add a barrier under the sentries (I’m assuming it’s a platformer) to make it so they won’t fall. You can make it invisible if you dont want it to be seen. This will block shots from the sentries though.
3 Likes
I tried that, but they just spawned below it
1 Like
Can you send us pictures of the sentry before you host and while you’re hosting?
1 Like
Ya. How do i put i photos??
1 Like
Screenshots.
1 Like
The Sentries are too low, you can see they’re slightly overlapping with the terrain. Sentries fall, so you can just move them up a bit so they don’t clip into the terrain while the game loads.
9 Likes
What do you mean span in a sentry?
1 Like
They probably mean spawn.
4 Likes
yea that’s normal it happens to me all the time just put the sentries in the air above the platform
1 Like
Place the sentry slightly above the terrain, props, or platforms rather than directly on them
Make sure your Map Settings – Items – Item Slots is set to 1 or more.
Place an invisible barrier block under the sentry
Try placing the sentry higher above the ground so it falls on the ground and not in the ground.
Move the sentries slightly off the ground. They have a massive hit box, and if any part of it touches the ground, they fall. Hope this helps! (BTW you can’t make sentries fly in Gimkit creative.)
you can if they have a invisible barrier
1 Like