@Blizzy Please Help

[DinoDogg128]

can u do that or is it easier not to

[DinoDogg128]

@NavyCatZ ?
no, it shouldn’t show cooldown

[NavyCatZ]

I can do that, I’m just saying it may be more complicated for you to do since it requires block code. Do you still want to proceed? Just like this comment if yes since you only get 10 replies when you make a new account.

[DinoDogg128]

no
its fine not showing the cooldown

[GeminiSlay]

welcome to the community @DinoDogg128

[mysz]

Welcome to our community, @DinoDogg128!

[DinoDogg128]

I am not new to Gimkit Creative, I have figured out fishing and farming on my own, and I have always read these posts, but without an account, but still, Thanks.

[NavyCatZ]

Place a game overlay. Set “overlay type” to “button.” Make the overlay text be “Track a Hider.” Connect the game overlay to 2 wire repeater devices and the relay I talked about earlier. Connect a wire repeater to the game overlay so it hides. Connect that same wire repeater to a new game overlay with text that is set to “On cooldown.” Connect that wire repeater to another wire repeater. In its settings, set “delay” to 30. Connect the wire repeater to both game overlays so it activates the button one and hides the cooldown one. Remember the second wire repeater that you connected the game overlay to? In its settings, set “delay” to 2. Connect the wire repeater to the waypoint device to deactivate it. I’m not sure if this works, but hope it helps.

(You have to use channels now. Refer to the newer post for more details.)

[NavyCatZ]

They’re referring to the fact that you’re new to posting on the forum, not gimkit.

[DinoDogg128]

K my bad, Sorry guys

[GeminiSlay]

it’s all good!

[NavyCatZ]

Tell me (or mark that comment as a solution) if it works.

[WhoAmI]

Is it possible to reuse the same waypoint for everyone if you set the scope to player with this system?

[wingwave]

Welcome to the community!

[EggNoodle]

From what @ClicClac told me in my help post:

1. Waypoint are limited onto one player. Using relays to make it track multiple players doesn’t work.
2. Wiring with waypoints are buggy. It is better to use channels.
3. If you using two waypoints but activate them on the same channel then the two waypoints might stick into a player.

Waypoint devices tracking player on a specific team (Resolved)

From what I could see: Don’t use wires. A basic trigger → waypoint setup adds a waypoint onto the person that triggered it. Adding in a relay causes… issues. Trigger → relay (all players) → waypoint: Puts a waypoint on the last player to enter the game, regardless of the amount of waypoints or players. IDK why Trigger → relay (all other players) → waypoint: Same thing. Trigger → relay ( specific team) → waypoint: Last player to enter that team.

Waypoint devices tracking player on a specific team (Resolved)

TLDR: you can only have one waypoint device on a player at a time. If you have multiple waypoints that activate from the same channel, they will be applied to the same person. [2023_07_24_0hl_Kleki] However, if you have two different waypoints that activate from two different channels, then they will latch onto two different players. [image] In this example, me and player four are on the same team. The relays are set to random player on team 2, and the channel format is what is down below. I…

[StacheIsTaken]

BUMP

[PotionMaster]

This is resolved and quite old post though

[thatOneCringe]

bump pls!

[CassiusDoomlorde]

This is necroposting. You don’t bump help topics.

[thatOneCringe]

just someting helpful
sorry tho.