Zone help with 2 zones

I have two zones, when I walk into one of the zones, I want the other zone to deactivate, but only for me, how do I do that.

1 Like

How to add Scope to Zones (0/10 or :white_large_square:)
Wasn’t this the solution to your previous topic?

2 Likes

Set the scope for the zone to “player” and you should be all good.

1 Like

There is none. plotwist

2 Likes

I’m not sure which zone it is talking about though

1 Like

Seriously? I swear they did. Check that guide then that @Bardy_2913 sent.

1 Like

The “zone” device.

1 Like

(This guy is going to ask a lot of questions…)
I suggest that you, as a beginner, use this:

1 Like

It says the zone you want to add scope to. Is that the zone that deactivates the other zone, or the zone being deactivated?

What does that have to do with this topic? Please keep the topic on topic and don’t derail it.

As I was saying, just use the guide…
It’s pretty simple by the looks of it and you just need to wire or set the channels correctly for it to work.

It’s the zone that deactivates the other zone.

Well, uhm
he is new to GKC
so I sent the documentation to help him with such

The documentation is linked in Gimkit’s official website right beside the link to this forum. Linking that is mostly unnecessary. Also as I’ve stated before, it’s off topic. Please, don’t derail topics.

Have the zone you walk into transmit on a channel that deactivates a trigger. For the other zone, have it transmit on a channel that triggers that trigger, which will then trigger something else.