so I uh was going to play a game on gimkit I log into the game and spawn in. I accidentally noclipped through the wall and I not even in creative mode I IN HOST MODE!
Is the spawn pad in the wall?
That just sounds like lag.
It’s probably just a normal glitch. Is the spawn pad near the wall? If it is move it a bit away from the wall.
You probably placed the spawn pad too close to the wall and clicked up. That happens all the time in other games. It’s not a bug and the way to fix it is by putting the spawn pad closer to the center than to the wall.
I back and normally when I spawn I don’t glitch outside the room this is where I suppose to spawn.
did not move the test person I only spawned him in btw.
when I move into any direction execpt up I don’t no clip
This could be because the spawnpad is really close to the wall.
Or just a glitch, probably too many tabs.
That is a problem with teleporters as well. If you move up into a teleporter you will be “offset” to the top on the connecting teleporter. Just move the spawn pad a bit down and that should fix the problem.
Example with teleporters:
(ignore the fragility, this is my testing map)
if the spawn pad spawns your Gim even a few pixels into the wall, going in the direction of the wall will clip through it
sniff sniff
mmm I smell glitches with the possible chance of breaking gimkit MMMM
cough
er-
does the glitch happen in any other GKC maps, and did it stay like that when you started the game?
