So I made a The Ascend of Mount Everest Gimkit creative and I just realized that in stage 5, where you fall from high areas into a underground cave with lots of water, you have to drain the water so you can move along deeper into the cave to find the exit, and you do that by pressing a button. However, when I made it and attached the wires and tested it out, the button wasn’t working! I don’t know what did this, maybe the gray barrier I put around the map to make the cave dark? Anyways, I tried adjusting things but it still wouldn’t work, and I’d appreciate it if someone could help 
–Jimmy
The barrier might have collision on.
If its on the player won’t be able to interact with the button.
Welcome to the Forums @Jimmy
Button pressed → deactivate barrier, right?
welcome to forums @Jimmy
make sure you read the guidelines and FAQ
No, the teleporter teleports the player to somewhere already INSIDE the barrier, so yeah.
1 Like
Yes exactly and I put the wires
Barriers have collision on by default but it can be turned off at the bottom of the all options tab.
Use channels?
Maybe?
I know but it still doesn’t work
Your Wi-Fi connection? Sometimes buttons don’t work for me too. Erase them and add them back.
I did I tried everything
Are you deactivating the WRONG barrier?
When I stepped on the button, nothing showed up (at the bottom center there is supposed to be a tap&hold to use button thingy)
1 Like
I am not doing that the barrier collision is off
1 Like
did the wire go to the wrong device?
No it is right at the device