How to make alternating lasers, no screenshots plz

[Chris10]

So, I just want lasers that alternate. 1 is on, 2 is off, then, 2 is on, and 1 is off. (1 and 2 are lasers, just using an example) i need it without screenshots because my screen doesn’t load any screenshots.

[Aguero10]

Use 2 lasers and for each one, use a laser beam manager. Then you can set it to the times you want. Tell me if you need a bit more detail .

[Chris10]

A bit more detail, maybe what to put in it

[mr.slime]

here, this will help your brain

The polarain way to alternating lasers!

I know someone already made this guide, but I found a way that uses less memory! Place two wire repeaters. , wire them like this: [Screenshot 2024-01-02 9.58.40 AM] Next, you place a laser, one wire repeater activates it, the other deactivates it, be sure to set a delay! If you want two or more lasers, I will make a diagram; the yellow wires show lasers activating, blue show them deactivating. [Screenshot 2024-01-02 10.04.44 AM]

@Chris10

I’ll try it and see what happens

k, cookie for everyone if it works

[Chris10]

I’ll try it and see what happens

[Aguero10]

So to break it down:
Place the 2 lasers where you want them to be and on each one (at the bottom of the settings) set the 1st laser to idk ‘laser 1’ and the second ‘laser 2’.
Then take 2 laser beam managers and place then near that laser. Set the first LBM (laser beam manager) to ‘laser 1’ and the second, ‘laser 2’.
Then set the times so that the first one has X seconds on, then Y seconds off then for the second LBM, set it to **Y seconds on, then X seconds off’. Make sure that X is the same for both and Y is the same for both.
Hope this helps!

[Aguero10]

@Chris10

The fact the laser are called laser 1 and 2​

That’s to make it easier to see. You can make them what you want but if I see laser 1 and laser 2, I know what they are. They are just like using X and Y in algebra because they can be anything.

[Chris10]

Thanks for helping! :]