I’m making a game inspired by other gimkit games, and I see games in discovery where the host is in a location, but when the host presses start, they are at a different location than the one that is seen when the host gives the code.
3 Likes
You can place down 2 spawn pads, on one of them, set it to “host only”, and on the other one, set it to “players only”
5 Likes
Welcome to the community!
Use the spawn pad and set it to only “spawn host” or something like that. And duplicate the spawn and set the spawn 2 to its player type to “player.”
See what happens.
And if it works, mark one of our posts a solution that looks like this.
Solution
4 Likes
Get a spawn pad in the place where the host game c0de place and make it pre-game, and where your game area in the other location put spawn pads and make the settings to “game”, so when the host presses start game everyone will spawn in the game place.
4 Likes
Hello! Welcome to the forum!
First you would place two spawn pads. Put them wherever you would like!
Click on the spawn pads you would like to use for “waiting for host”
Change the spawn pad’s settings into: Use during Phrase >> Pre-Game
Next, click on the other spawn pads you would like to use when the game starts.
Change their settings to: Use during Phrase >> Game
Then you have it! If this helps you may mark this as solution.
2 Likes