I have found a bug. For some reason, whenever I copy a checker and attempt to activate it, the checker simply won’t run. I have to manually create a new checker. Is anyone else experiencing this with their checkers?
Is it being activated & triggered with wires or channels? Wires don’t carry over when you copy devices (with 1 exception, but if you just copied the checker this won’t apply).
This usually means that the checkers aren’t actually there, even though it looks like they are. This is a common bug that has yet to be fixed.
2 Likes
I copied the checker and re-wired it. The system is that I click a button, it runs the check, when the check passes, it deactivates a barrier and the button, and on a bad check, it sends a notification. I copied the other components as well and rewired them the same way.
When I copy the checker, I also copy the entire system. I can edit the checker and everything just fine when I copy them.
The original system works, right?
And the system does not work after you copied wire and checker and deleted the original checker, right?
Just making sure
I copied the entire system, then rewired it.
However, I have noticed that this bug happens only sometimes.