I copy and paste some devices
It is two props a barrier and a sentry
It show up in editing mode but it I play the game or reload either the devices or props show up never both
I don’t expect that there will be a solution but if you know why this is happening, please tell me
2 Likes
that also happens to me
So you’re selecting a few devices with your cursor, then doing Command C (or whatever it is), then Command V? Try going into the settings of each device after pasting and editing something and then reverting it back, then try reloading. Might help.
That doesn’t work
What devices are you using?
They’re not set to be invisible during game start or because of a channel/wire, right?
Is it a layers issue? Oops sorry JaydoPotato.
1 Like
Move the layers and see if adjusting them works!
Barrier = Lowest layer
Sentry = Middle
Plant Canister = Middle (Higher than sentry)
You’re perfectly fine!
Are you copying and pasting them all at once?
@Skizzle
prolly a bug but may have something to do with layering?
copying and pasting is buggy for me too for sure
yes It just whenever you copy devices and props at the same time it doesn’t work
ya its so annoying
Did you try @JaydoPotato’s reply? It seemed like it could work…
No but it would mess up the visuals of my map and I’d rather add them manually
Okay, and there’s nothing wrong with the settings, right?
This never happens to me, I feel like it’s so strange.
Would you try it, just to see if it’s the issue?
Maybe changing the layers would mess… something else up?
Nope check it multiple times
What do you mean?
I think it’s because you have a barrier included.