Barrier Deactivation Timing in Gimkit Creative

[ProPlayer95]

There are multiple barriers in a game. Each barrier should deactivate one by one, 30 seconds before each full minute (e.g., at 0:30, 1:30, 2:30, etc.). What is the best way to set this up in Gimkit Creative by using triggers?

First barrier deactivate at 0:30
Second barrier deactivate at 1:30
And then cycle keeps going until 50 or 100 barriers.

[serial_destination_V]

maybe a trigger look connected to timers that when hits the end of the timer deactivate the barrier

[ProPlayer95]

I need it for more than 50 barriers and it should be 100% accurate

[serial_destination_V]

then i dont know how sorry

[WilliamWin_1]

The only thing that comes into my mind are repeaters, properties, and blocks in triggers.

[JerryMusado]

Make a trigger on every barrier so then wire the trigger to a wire repeater so then set the delay to 30 so then wire the repeater to the barrier.